Toshiba TCB-SC640U-E - Setting the Clock (Clock)

Central Remote Controller Installation Manual
17
-EN
5 "Servicing Menu" Settings
■ How to Display the "Servicing Menu" Screen
■ Servicing Menu Items
1 Display the "All" screen
2 Press [ ] (Menu) and [ ] (Control) together for
more than 4 seconds
The "Servicing Menu" screen appears.
3 Press [˄] and [˅] to select the item, then press [ ]
(Confirm)
For details on the setting contents of each item, refer to "■Servicing Menu
Items".
No. Setting Items Description
Reference
Page
1 Address Settings
Obtain Address
Obtains (register) indoor units and changes the Central control
address.
P.18
Address Display Displays the registered indoor unit addresses. P.20
Address Auto-setting Sets the Central control address automatically. P.20
2 Zone Settings
Central control address
Assigns the registered indoor units to zones 1 to 10. P.21
Line Address
Delete zone setting Deletes all zone settings. P.23
3 Display Settings
Daylight-saving
Sets whether to display the daylight-saving time setting in the clock
setting.
P.24
Temperature Display Conf. Sets the temperature display unit (°C/°F) and interval (1°C/0.5°C). P.24
Unit order setting Changes the display order of indoor units on the Unit screen. P.25
4 Check/Notice Settings
Delete check history Deletes the check code history. P.26
Notice Settings Sets the notice code and deletes the history. P.26
5 External Input Settings Sets the function to DI1 to DI3. P.27
6 CRC Mode Change Conf.
Switches between Central control address Control Mode and Local
Control Mode.
P.29
7 DN setting Only service personnel should perform this work. P.29
8 Communication Conf. Changes the Communication Conf. P.30
9 Communication Check
Connection Confir. List
Displays the current operation status of the Central control addresses 1
to 128.
P.32
Communication Quality Displays the Communication Quality. P.32
10 Register Contact Info Contact TEL No.
Enter the contact information (service store telephone number) for
when an error occurs.
P.33
11 ALL Unit ON/OFF Setting Switches the target for simultaneous ON / OFF. P.34
12 Air to Water Setting Switches the target Air to Water Heat Pump unit for ON / OFF. P.34
(Control) button
(Menu) button
"All" screen