Central Remote Controller Installation Manual
22
-EN
When "Central control Address" is selected
To Change the Group Zone of Multiple Indoor Units
1 Perform steps 1 to 2 in "Change the Zone to which the
Indoor Unit Belongs" (P.21).
The "Address List" screen is displayed.
• You can set either "Central control Address" or "Line Address".
2 Put the cursor on the first address, and then press [≡]
(Menu) and [ ] (Confirm) at the same time.
Multiple units are selected.
• If you press [ ] (Return), the selection of multiple units is cancelled, and
the cursor returns to the first address.
3 Select the last address by using [<], [˄], [˅], and [>],
and then press [ ] (Confirm).
The "Zone List" screen is displayed.
4 Select a zone number by using [<], [˄], [˅], and [>], and
then press [ ] (Confirm).
The "Address List" screen returns.
• The selected zone no. is displayed to the right of the address.
• The number in < > is the number of units for which the zone No. is set.
• You can make the settings for up to 64 units.
• An error screen is displayed if you set 65 or more units.
To Next Page
Loading...
