Toshiba TCB-SC640U-E - Setting the Clock (Clock)

Central remote controller Owner’s Manual
17
-EN
●REQUIREMENT
The clock must be set before start using this central remote controller.
If the clock is not set, clock display blinks and the schedule does not operate.
If the clock is not set, Check code / Notice code history will not recorded with correct time.
Clock
● NOTE
• If the clock is not set, the clock displayed in the upper right of the All, Zone, or Unit screen blinks.
• The retention period in case of a power outage is approximately 3 days.
• If power is not supplied for a long period of time, the clock is initialized to “2020 01 01 00:00”.
Setting the Clock (Clock)
1 In the “Settings Menu” screen, select “Clock” and then press
[ ] (Confirm).
The “Clock setting” screen is displayed.
2 In the “Clock setting” screen, select “Clock” and then press
[ ] (Confirm).
The “Clock” screen is displayed.
3 Move the cursor using [<] and [>], change the year, month,
day, and time using [∧] and [∨], and then press [ ] (Confirm).
The “Clock setting” screen is displayed again.