CAUTION
Never insert your finger into the disc hole when load the disc to the disc slot. Keep your
fingers well clear of the disc slot when disc is loading or unloading. Neglecting to do so
may cause personal injury.
■ Notes
Strong static electricity may affect the DVD player’s operation and cause it not to work
properly. If this happens, please try followings.
(1) Press
/
key for 5 seconds. DVD player will eject the disc.
(2) If DVD player still don’t work, turn OFF the POWER, disconnect and then reconnect
the AC power cord, and turn ON the projector again.
To start playback in the stop mode:
Press
/
or
To pause playback (still mode):
Press
/
or during playback.
To resume normal playback, press
/ or
• The sound is muted during still mode.
• If
is pressed during pause, DVD plays frame by frame .
To stop playback:
(1) Press
/
or
To remove the disc:
(1) Press
/
during stop or .
(2) Remove the disc after the disc comes out.
■ Notes
• If a non-compatible disc is loaded, “WRONG REGION” will appear according to the type
of loaded disc. In this case, check your disc again.
• Some discs may take a minute or so to start playback.
•
If you insert a single-sided disc the wrong way, “READ” will appear on the display for about
20-40 seconds. Then “NO DISC” will display and the disc will be ejected automatically.
• Some discs may not resume playing the same scene after stopping.
• Some playback operations of DVDs may be intentionally fixed by software producers.
Since this projector plays DVDs according to the disc contents the software producers
designed, some playback features may not be available. Also refer to the instructions
supplied with the DVDs.
• Do not move the projector during playback. Doing so may damage the disc. If you want to
move the projector to other place or room, be sure to eject the disc and turn off the power
beforehand.
To Next Page
Loading...
