Toshiba TDP ET20/U - Using Menus; How to Use the Menus

41
Operations
You can call up on-screen menus, and conduct a number of adjustments and settings using the
operation buttons
p.18
p.19
on the control panel (main unit side) and remote control.
■
How to use the menus
The menu shown below is for operation instructions purposes and might differ from the
actual display.
1. Press the [MENU] button.
Display the menu.
2. Select a category.
3. Adjustment & Settings
Press to enter the selected category. Select item with / [UP] [DOWN] key and
press again.
Using menus
Select the category using
 
/
[UP] [DOWN] key. There are fol-
lowing 5 categories:
Input menu
p.42
Picture setting menu
p.42
Audio setting menu
p.45
Setup menu
p.46
Status display menu
p.47
Displays the current
adjustments and
settings of selected
category.
Item shown with gray
cannot be adjusted
with the current input
source.
4. Press the MENU button.
The category selecting menu is displayed.
5. End Press the MENU button.
(The menu disappears 30 seconds after the last operation.)
Item
Adjusting / Setting value
key
[MENU] key
key
[MENU] key
Press
key to adjust.
Current setting
Press
key to select desired item and press key.
The figure shows displays given for operation instructions purposes. As the display may differ
depending one the item, use the following pages as a reference.