Toshiba TDP-WX5400 - Securing the Lens Using the Anti-Theft Screw; Installing the Optional Color Wheel (Provided)

32
33
Preparations
Securing the lens using the anti-theft screw
Using the anti-theft screw to prevent theft of the lens. Tighten the supplied anti-theft screw
on the front bottom.
Installing the optional color wheel (provided)
This projector comes with a four-segment color wheel installed. An additional six-segment color
wheel is also provided. To replace the color wheel (located under the lamp cover adjacent to
lamp 1) refer to the following guide.
Note
Wait until the lamp housing and the color wheel cool off.
1
Loosen the captive screw (A) on the lamp cover.
2
Remove the lamp cover by sliding it in the direction of the arrow (B).

•
Anti-theft screw hole
for lens unit
Anti-theft screw
A
B
3
Unscrew the retaining screws (x 4) on the four-segment color wheel.
4
Lift the color wheel in the direction shown.
5
Insert the six-segment color wheel.
Installing or removing the projection lens (Continued)