Toshiba TDP-WX5400 - Freezing the Image (Freeze); Setting the Password

44
45
Operations
Freezing the image (Freeze)
This function is used to pause or freeze a video during a presentation.
Press the remote control’s FREEZE button.
The picture will pause. To release the freeze function, press the
FREEZE button again.
Notes
Other operations will also release the freeze.
Even if an image is frozen on the projector, the pictures are
running on the video or other equipment.
Using this function on commercial video software, broadcast or cable-
broadcasting except for the purpose of your private viewing and
listening may infringe the copyright protected by the copyright laws.
Setting the password
How to set password (from [Off] to [On])
To set the security password, refer to the
following guide.
1
Press the Menu button on the projector
or remote control to display the Main
Menu. Scroll to the [Setting] menu using
p
or
q
and press Enter.
2
Select [Setting 2] using
t
or
u
and
press Enter.
3
Select [Password] using
p
or
q
and
press Enter.
4
Select [On] then [OK] and press
Enter.
The password entry screen is displayed.
5
Enter a password between 4 and 10
characters using the arrow keys of
the remote control. Press Enter.
6
Re-enter the password for
conrmation and press Enter.
7
Select [OK] using the remote control and
press Enter to enable the password.
Note
Please do not forget your password. If you forget the password, you can not release the
password by yourself.
In such a case, please contact your dealer.
•
•

•
•
•

Remote
control
How to operate when password is [On]
1
Turn on the power.
2
The lamp lights and the password entry screen appears.
3
Enter the password using the arrow keys of the remote control.
If the entered password is correct, the start-up screen appears and the projector
goes into normal operation. If the password is wrong, a message will appear
prompting you to re-enter the password, and the password entry screen is displayed
again. If you enter an incorrect password for more than 5 times, the projector will
automatically power off and enter standby mode.
Note
When the password setting is [On], the password will be enabled only when the
power is turned on for the rst time after the main power switch has been on.
The password function will not be activated if the power backed on while it is
standby mode without turning off the main power switch.
How to set password (from [On] to [Off])
1
Select [Password] in the
[Setting 2] menu and press
Enter.
The password entry screen is
displayed.
2
Enter the password using
the arrow keys of the remote
control.
3
Select [Off] and press Enter
to disable the password.
•
Using handy features (Continued)