54 55
Operations
The Advanced menu
Item
p
q
Description
Computer 1 Computer 2 Computer 3
Y/PB/PR
Video
S-video
Noise
reduction
*1
Adjust the screen noise
reduction level.
Off/Low/Mid/High
Yes Yes Yes Yes Yes Yes
3D Y/C
separation
Enbale or disable 3D Y/C
separation.
On/Off
No No No No Yes No
Progressive Adjust the progressive mode.
Off/Still/Standard/Cinema
No No No Yes Yes Yes
Color matrix Set the default Color matrix.
Auto/RGB/SDTV/HDTV
Yes Yes Yes Yes No No
Film Set the Film mode.
Off/2-2/2-3 Auto/2-2/2-3
No No No Yes Yes Yes
*1: Noise reduction may not work depending on signal type.
Using the Adjust menus (Continued)
Using the Setting menus
The Setting menu contain the most often used settings during installation and options
to customize the general output of the projector. Three tabs are accessible through the
Setting menu; Setting 1, Setting 2, and Setting 3.
The Setting 1 menu
Item
p
q
Description
Keystone
Adjust the horizontal/vertical keystone values. Press
and adjust the keystone using
t
u
.
Lamp power
Set the lamp power. Press
and select the lamp power using
p
q
.
Low/Standard
Lamp mode
Set the lamp mode. Press
and select the lamp mode using
p
q
.
Dual/Lamp1/Lamp2
Lamp interval Set the period of time after which the lamp should be swapped when lamp select is not set
to Dual mode. Press
and select the lamp interval using
p
q
.
Off/1 week/4 week/2000H
Language Select one of the languages below to use for displaying the menu and messages
Press
and toggle the display language using
p
q
.
/ / / / / / /
中文
(
簡體字
)
Lens Shift Shift the lens using the projector's control panel.
•
Press
to display the Len shift window.
•
Press
p
qt
u
to shift the lens in the corresponding direction.
Zoom
Use the Zoom feature from the projector's control panel.
•
Press
to display the Zoom window.
•
Press
t
to zoom out and
u
to zoom in.
Focus
Use the Focus feature from the projector's control panel.
•
Press
to display the Focus window.
•
Adjust the focus by pressing
t
and
u
.
Notes
For lamp protection, [Lamp mode] cannot be changed its setting mode right after you
have switched the lamp mode or the lamp has turned on. If it is the case, allow some
time before changing the mode.
•
To Next Page
Loading...
