To replace the lamps, refer to the following instructions.
1
Unplug power cord.
2
Wait until lamp is sufciently cooled.
3
Loosen the captive screw (A) on the lamp cover.
4
Remove the lamp cover by sliding it in the direction of the arrow (B).
5
Loosen the two captive screws (A) on the lamp module. Lift the module
handle up (B) in the direction shown.
6
Pull rmly up the module handle to remove the lamp.
7
Replace the lamp as shown.
Note
The lamps are positioned differently. Take extra caution not to force the lamps
when replacing.
8
Reverse steps 3 to 5 to install the new lamp module and replace the lamp cover.
Note
The lters should be replaced when replacing the lamp modules.
•
•
Replacing the lamps (Continued)
To Next Page
Loading...
