Toshiba TDP-WX5400 - Replacing the Filters; Resetting the Filter Time Counter

72
73
Maintenance
When the lamps are replaced, the lters should also be replaced, not cleaned.
Refer to the following guide to replace the lters.
CAUTION
Do not drop the projector on your hand or ngers while lifting the projector to
replace the lters. Doing so could injure your hand or ngers.
•
Note
The side and the rear lters can be pulled out from
the slots located at the bottom as shown.
1
Gently slide the lter holders in the direction
shown.
2
Lift the lter foams from all three lter
holders in the direction shown.
Remove them completely from each lter
holder and discard.
3
Place a replacement foam and press down
rmly.
4
Replace the lter holders by pushing gently
in the direction shown.
Note
When dirt and dust build up in the filter, the air circulation inside the projector is
affected and the internal temperature will rise, causing the projector to stop working or
malfunction.
Be sure the lter is inserted all the way into the slot. Leaving gaps will allow dust and
dirt to get inside the projector again.
When you purchase a new lamp, new lters are also provided. If a lter is torn or dirty,
please replace with new one. Continuing to use a ripped lter will allow dust and dirt to
get inside the projector.
Never run the projector with the lters removed. It is recommended that you clean the
•
•
•
•
•
Replacing the lters
Bottom
Resetting the lter time counter
After replacing the lters, the lter time counter should be reset to zero. Refer to the
following guide:
1
Press the MENU button on the control panel or remote to open the Main menu.
2
Press the
p
or
q
button to move to the [Reset] menu and press Enter.
The [Reset] menu is displayed.
3
Select [Clear lter time] using
p
or
q
and press Enter.
A conrmation box is displayed.
4
Select OK using
t
or
u
and press Enter to reset the lter time to zero.
