Toshiba TDP-WX5400 - Screen Trigger

80
Specications (Continued)
Pin assignment of COMPUTER 1 IN
Pin No.
Pin description
RGB Signal (analog) Y/Cb/Cr Signal
1 Red Cr
2 Green or Sync on Green Y
3 Blue Cb
4 Ground
5 Ground
6 Red Ground Cr Ground
7 Green Ground Y Ground
8 Blue Ground Cb Ground
9 No Connection
10 Sync Signal Ground
11 No Connection
12 Bi-directional Data (SDA)
13
Horizontal Sync or Composite
Sync
14 Vertical Sync
15 Data Clock
Screen Trigger
When the projector is powered ON, the screen trigger output sends a low voltage trigger to
the screen controller and the screen will go down. When the projector is powered OFF, the
screen trigger stops sending a low voltage trigger to the screen controller and the screen
will go up.
Note
To use this feature, you must turn on the Screen Trigger function
p.58
.
Note
Screen controllers are supplied and supported by screen manufacturers.
Do not use this jack for anything other than intended use. Connecting the wired remote
control to the SC. TRIGGER Mini Jack causes damage to the remote control.


•
•
•
Mini D sub 15 Pin connector
51
10
1511
6