4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33012B
(Revision Date Apr. 24, 2008)
4.22 RFID MODULE (B-SX704-RFID-U2-EU-R)
4-129
The following parts are required when short-pitch tags (20 mm) are used. Keep them safe when not in use.
• Shield Plate (1 pc.)
• Shield Sheet (1 pc.)
• Antenna Plate L (1 pc.)
• Antenna Plate R (1 pc.)
• Pan Head Screw
P-3x6 (6 pcs.)
4.22.3 Installation Procedure
4.22.3.1 Preparation for Use of Short-Pitch RFID Tags (20mm)
When short-pitch tags (20 mm) are to be used, the Antenna Ass’y and the Antenna Frame need to be
converted before installing an RFID module in the printer, for proper read/write operation. When short-pitch
tags are not used, skip this section and go to Section 4.22.3.2.
1. Remove the two Tapping Screws to detach the Antenna from the Antenna Ass’y.
Tapping Screw
Antenna
Antenna Ass’y
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
To Next Page
Loading...
