4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.4 RIBBON SAVING MODULE (B-9904-R/R2-QM)
4-19
4.4 RIBBON SAVING MODULE (B-9904-R/R2-QM)
All the following parts are supplied with the kit. Make sure you have all items shown below.
NOTE: The ribbon saving module is standard on the B-SX5T series.
Solenoid (1 pc.) RSV PC Board (1 pc.) Solenoid Harness (1 pc.)
Cable Clamp (1 pc.) Locking Support (3 pcs.)
• Installation Manual (1 copy)
• SM-4x8 Screw (2 pcs.)
NOTES: 1. The B-9904-R2-QM Ribbon Saving Module is available only with Firmware V1.2A or greater.
Please be careful that the earlier firmware version does not support it.
2. The insulation tape of the solenoid of the B-9904-R-QM is blue, and that of the B-9904-R2-QM
is black.
1) Remove the side panel (L) from the printer. (Refer to section 3.2.)
2) Remove the operation panel ass’y from the printer. (Refer to section 3.4.)
3) Fit the three locking supports into the RSV PC board.
RSV PC Board
Locking Support
Insulation Tape
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
To Next Page
Loading...
