4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.9 RIBBON SAVING MODULE AND ROTARY CUTTER (For B-SX4T Series)
4-35
4.9 RIBBON SAVING MODULE AND ROTARY CUTTER (For B-SX4T Series)
When using the rotary cutter on the B-SX4T series, the ribbon saving module needs to be installed,
also. In this section, how to install the ribbon saving module and rotary cutter is described.
Ribbon Saving Module
All the following parts are supplied with the kit. Make sure you have all items shown below.
Solenoid (1 pc.) RSV PC Board (1 pc.) Solenoid Harness (1 pc.)
Cable Clamp (1 pc.) Locking Support (3 pcs.)
• Installation Manual (1 copy)
• SM-4x8 Screw (2 pcs.)
NOTES: 1. The B-9904-R2-QM Ribbon Saving Module is available only with Firmware V1.2A or greater.
Please be careful that the earlier firmware version does not support it.
2. The insulation tape of the solenoid of the B-9904-R-QM is blue, and that of the B-9904-R2-QM
is black.
Rotary Cutter
All the following parts are supplied with the kit. Make sure you have all items shown below.
Cutter Unit (1 pc.)
Cutter Cover (1 pc.) Cutter Drive Unit (1 pc.) Harness Ass’y
(2-pin & 9-pin) (1 pc.)
Cord Bush (1 pc.)
Print Head Cleaner (1 pc.)
(P/No.: FMQB0051601)
B-SX Cutter Paper Guide C
(1 pc.)
• Installation Manual (1 copy)
•
SM-4x8 Screw (6 pcs.)
Insulation Tape
Mantenimiento Periféricos Informáticos C/Canteras,15 28860 Paracuellos de Jarama Madrid Tel: 91 748 16 04 www.mpi.com.es
To Next Page
Loading...
