Toshiba TECRA 9100 Series - Executing the Diagnostic Test

3.2 Executing the Diagnostic Test 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-3
3.2 Executing the Diagnostic Test
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
1. Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
NOTE: To execute the CD-ROM or DVD-ROM test, make sure the CD-ROM and CD-
ROM drive or DVD-ROM and DVD-ROM drive is installed in the computer and the
external FDD is attached to the USB port.
The following menu will appear:
TOSHIBAPersonalComputerxxxxxxxDIAGNOSTICS
VersionX.XX(C)CopyrightTOSHIBACorp.XXXX
DIAGNOSTICSMENU:
1-DIAGNOSTICTEST
2-HARDDISKFORMAT
3-
4-HEADCLEANING
5-LOGUTILITIES
6-RUNNNINGTEST
7-FDDUTILITIES
8-SYSTEMCONFIGURATION
9-EXITTOMS-DOS
0-SETUP
↑↓
→← :Selectitems
Enter:Specify
Esc:Exit
NOTE: To exit the DIAGNOSTIC TEST MENU, press the Esc key. If a test program is in
progress, press Ctrl + Break to exit the test program, or press Ctrl + C to stop the test
program.