Toshiba TECRA 9100 Series - Accessing the SETUP Program

3.24 SET UP 3 Tests and Diagnostics
TECRA 9100 Maintenance Manual (960-347) 3-55
3.24.2 Accessing the SETUP Program
Selecting 0 from the DIAGNOSTICS MENU and pressing Enter displays the TSETUP
screen. The TSETUP screen is divided into two pages: SYSTEM SETUP (1/2) and SYSTEM
SETUP (2/2).
Total = XXXXX KB
Battery Save Mode = User Setting
Not Registered
Power On Display = Auto-Selected
LCD Display Stretch = Disabled
Boot Priority = HDD→FDD→CD-ROM→LAN
HDD Priority
= Built-in HDD→Second HDD
Power On Boot Select = Enabled
SYSTEM SETUP (1/2)
Pointing Devices = Auto-Selected
Ext Keyboard "Fn" = Disabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE (Normal)
Device Config. = Setup by OS
Serial = COM1(3F8H/IRQ4)
Parallel = Not Used
Built-in LAN = Enabled
Built-in HDD
= Primary IDE(1F0H/IRQ14)
Select Bay
= Secondary IDE(170H/IRQ15)
PCI BUS = IRQ11
SYSTEM SETUP (2/2) ACPI BIOS version = x.xx
Controller Mode = Auto-Selected
Power-up Mode = Boot
CPU Cache = Enabled
Level 2 Cache = Enabled
Processor Serial Number = Disabled
Dynamic CPU Frequency Mode
= Dynamically Switchable
Auto Power On = Disabled
USB KB/Mouse Legacy Emulation
= Enabled
USB-FDD Legacy Emulation = Enabled
PERIPHERAL
BATTERY
DISPLAY
PASSWORD
MEMORY
OTHERS
BOOT PRIORITY
CONFIGURATION
I/O PORTS
PCI BUS
LEGACY EMULATION
PC CARD
DRIVES I/O
PCI LAN
ACPI BIOS version = x.xx
↑↓→←:Select items Space,BkSp:Change values PgDn,PgUp:Change pages
Esc:Exit without savin
g
Home:Set default values End:Save chan
g
es and Exit