Toshiba TECRA 9100 Series - Bluetooth Test Program

3 Tests and Diagnostics 3 28 Bluetooth Test Program
3-80 TECRA 9100 Maintenance Manual (960-347)
3.28 Bluetooth Test Program
This section describes how to perform the Bluetooth test program to check if the Bluetooth
functions of computer are working properly. To start the Bluetooth test program, follow the
steps below:
Note:
Use another computer that can communicate by the Bluetooth as a reference
machine to perform this test.
Insert a floppy disk containing the test program into the target machine and turn on the target
machine. The following Bluetooth test menu will appear:
######### Bluetooth sub system test program VX.XX ########
.... Press test number[1-2,T] ?
############################################################################
****************************************************************************
* *
* 1 ............ BD_ADDR check *
*
* 2 ............ communication test ( DUT mode ) *
############################################################################
* *
* *
* *
* *
* T ............ communication test ( TEST mode ) *
Press 1 or 2 key to perform the corresponding sub test. To quit the Bluetooth test program,
eject the floppy disk and turn the computer off while the menu above is displayed.