4.2 HDD 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-17
Installing the HDD
To install the HDD, follow the steps below and refer to figures 4-5 to 4-8.
CAUTION: Don't hold the HDD by its top and bottom flat surfaces. It may
damage the HDD.
1. Connect the connector.
2. Seat the HDD in the bracket.
3. Secure four M3×4 flat-head screws.
CAUTION: Do not apply pressure to the middle of the HDD pack. It may
damage the HDD bracket. Hold the HDD by its corners.
4. Hold the HDD pack by its corners and insert it into the computer. Press to ensure a
firm connection.
5. Insert the white plastic tab into the gap between the computer top cover and the
HDD, and seat the cover.
6. Secure the HDD cover with one M2.5×4 silver flat-head screw.
To Next Page
Loading...
