Toshiba TECRA 9100 Series - Installing a Memory Module

4 Replacement Procedures 4.3 Memory Modules (Option)
4-20 TECRA 9100 Maintenance Manual (960-347)
Installing a Memory Module
To install a memory module (option), make sure that the computer is in boot mode and
powered off, follow the steps below and refer to figures 4-9 and 4-10.
CAUTION: Do not touch the connectors on the memory module or on the computer.
Debris on the connectors may cause memory access problems.
1. Fit the expansion memory module’s connectors into the computer’s connectors and
press carefully to ensure firm contact.
2. Gently, push the expansion memory module down until latches on either side
engage the expansion memory module to hold it in place.
3. Align two tabs on the edge of the expansion memory slot cover with two notches on
the memory slot, and seat the expansion memory slot cover.
4. Secure the expansion memory slot cover with two M2.5×3 silver screws.
CAUTION: Do not install a memory module in slot B only. Use slot A prior to slot B.
Otherwise, the computer or the memory may be damaged.