Toshiba TECRA 9100 Series - Slim Select Bay Module; Removing the Slim Select Bay Module

4.4 Slim Select Bay Module 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-21
4.4 Slim Select Bay Module
Removing the Slim Select Bay Module
NOTE: Removal of the Slim Select Bay module is the same for all modules. For
instructions on disassembling each component, refer to the relevant section in this
chapter.
To remove the slim select bay options, follow the steps below and refer to figure 4-11.
1. Turn the computer upside down.
2. Slide the release lever in the direction of the arrow, and pull out the slim select bay
module.
CAUTION: The Slim Select Bay module can become hot with use.
Be careful when removing the module.
Slim select bay module
(for example DVD-ROM Drive)
Latch
Figure 4-11 Removing a Slim Select Bay Module