4.8 Top Cover with Display Assembly 4 Replacement Procedures
4-37 TECRA 9100 Maintenance Manual (960-347)
Installing the Top Cover with Display Assembly
To install the top cover with display assembly, follow the steps below and refer to figures
4-20 to 4-23.
1. Be careful to route the Bluetooth antenna coaxial cable and wireless LAN antenna
coaxial cables so that the top cover with display assembly will not pinch them.
2. Seat the top cover.
3. Press along the edges of the top cover with display assembly to secure latches.
4. Connect the LCD/FL cable to PJ76 and route the Bluetooth antenna coaxial cable.
5. Connect the IPS Switch cable to PJ122.
6. Connect the speaker cables to PJ127 and PJ129.
7. Secure the following five screws:
• Two M2.5×8 black screws
• Two M2.5×3 silver flat-head screws
• One M2.5×4 black flat-head screw
8. Turn the computer upside down and secure the following 12 screws:
• One M2.5×8 black flat-head screws
• Six M2.5×16 screws
• Four M2×12 black flat-head screws
• One M2.5×4 screw
To Next Page
Loading...
