4.13 IPS Board 4 Replacement Procedures
4-51 TECRA 9100 Maintenance Manual (960-347)
4.13 IPS Board
Removing the IPS Board
To remove the IPS Board, follow the steps below and refer to figure 4-32.
1. Lay the top cover and display assembly upside down.
2. Remove three M2.5×4 silver flat-head screws securing the IPS Board.
3. Remove the IPS board.
M2.5×4 silver flat-headscrews
Figure 4-32 Removing the IPS board
To Next Page
Loading...
