Toshiba TECRA 9100 Series - Installing the LCD Module

4.23 LCD Module 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-77
Installing the LCD Module
To install the LCD module, follow the steps below and refer to figures 4-47 to 4-49.
1. Seat two metal braces and secure each with two silver flat-head M2×3 screws.
2. Connect the LCD/FL cable to the LCD module.
3. Secure the LCD/FL cable with the tape.
4. Seat the LCD module and secure it with four M2×5 screws.
CAUTION: Make sure the cables lie inside the guide. Be careful not to damage or pinch
any cables when you seat the LCD module.