4 Replacement Procedures 4.25 LCD/FL Cable
4-84 TECRA 9100 Maintenance Manual (960-347)
4.25 LCD/FL Cable
Removing the LCD/FL Cable
To remove the LCD/FL cable and antenna coaxial cable, follow the steps below and refer to
figures 4-55 to 4-58.
NOTE: When you open or close the top cover, hold it by the sides close to the hinges to
prevent damage.
1. Remove two silver M2.5×6 screws securing the metal plate.
LCD/FL cable
Metal plate
M2.5×6 silver screws
Figure 4-55 Remove two silver screws securing the metal brace
To Next Page
Loading...
