4 Replacement Procedures 4.26 FL (Model 14.1 XGA Toshiba)
4-90 TECRA 9100 Maintenance Manual (960-347)
5. Fold out the X and Y-PCB insulation sheets as illustrated below. Don't lift up them
from the side of the frame.
6. Remove the screws from the left side, top side and right side of the frame in the order
illustrated below.
7. Remove the FPC from the connector.
8. Unfold the bent part on the frame.
NOTE: Use a No. 0 Phillips screwdriver to remove the screws. Do not damage the
Y-PCB when you pull the FPC out of the hook on the frame.
2
Screw
Screw
Screw
Screw
1
1
1
1
Screw
Screw
Screw
Screw
2
2
2
Figure 4-60 Folding out the insulation sheets and removing the screws and FPC
To Next Page
Loading...
