Toshiba TECRA 9100 Series - Installing the TFT FL (Model 14.1 Toshiba)

4.26 FL (Model 14.1 XGA Toshiba) 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-95
Installing the TFT FL (Model 14.1 Toshiba)
To install the TFT FL (Model 14.1 Toshiba), follow the steps below and refer to figures 4-64
to 4-69.
1. Install the U-shaped hook of the high-voltage side of the reflector into the frame.
2. Apply one strip of double-faced tape to the center of the reflector.
3. Fit the low-voltage FL cable into the frame.
4. Install the reflective sheet and the light guide.
5. Install four lens sheets.
6. Check the module as shown below.
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Secure the tab on the prism sheets firmly
with the sheet-holding tape.
Figure 4-64 Checking the module