4 Replacement Procedures 4.26 FL (Model 14.1 XGA Toshiba)
4-96 TECRA 9100 Maintenance Manual (960-347)
7. Remove the liner from the double-faced tape on the top side of the frame of the
backlight unit.
8. Make sure there is no dust, foreign matter or damage on the backlight or back side of
the cell, then install the PCB-ASSY cell onto the backlight unit.
NOTE: Align the bottom left corner as illustrated below.
Cell with PCB
Back light
Figure 4-65 Installing the PCB-ASSY cell
To Next Page
Loading...
