4.26 FL (Model 14.1 XGA Toshiba) 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-97
9. Fold the X-PCB and Y-PCB onto the back of the backlight unit in the order illustrated
below.
10. Insert the FPC into the hook on the frame.
11. Connect the FPC to the connector and secure it with the latch of the connector.
1
2
X-PCB
Y-PCB
FPC
PCB must not protrude
beyond the surface of the frame.
Cover the outlet
of the cable with the rubber cap.
Insert the FPC into the hook
on the frame.
Figure 4-66 Folding the X-PCB and Y-PCB
To Next Page
Loading...
