4 Replacement Procedures 4.26 FL (Model 14.1 XGA Toshiba)
4-98 TECRA 9100 Maintenance Manual (960-347)
12. Install the frame.
NOTE: Make sure that the GND-CU of the Y-PCB is inside the frame and that the lamp
reflector at the lower left side is inside the frame.
1
1
1
1
1
2
The cable must not protrude
beyond the frame.
Fold the bend parts
Must not protrude beyond the frame.
The GND-Cu of the PCB is
inside the frame.
Apply aligning with the edge of the rubber cap.
Apply aligning with the edge
of the rubber cap.
Figure 4-67 Installing the frame
To Next Page
Loading...
