4 Replacement Procedures 4.27 FL (Model 14.1 XGA Sharp)
4-106 TECRA 9100 Maintenance Manual (960-347)
5. Secure the ground wire with one strip of tape.
6. Make sure the LCD panel fits into the panel guide ribs.
7. Hook the U-shaped side of the top frame to the P-chassis, then lay the top frame on
the LCD module.
8. Secure the top frame with two latches on the lamp side.
U-shaped side of the top frame
Latches
Figure 4-76 Installing the top frame
9. Secure five screws on the side of the top frame. Make sure two latches on the lamp
side of the top frame secure the top frame firmly.
Screws
Screws
Tighten the screws with 0.1176N⋅m (1.2kgf⋅cm) of torque.
Latches
Figure 4-77 Securing the screws
To Next Page
Loading...
