4.28 FL (Model 14.1 SXGA+ Sharp) 4 Replacement Procedures
TECRA 9100 Maintenance Manual (960-347) 4-113
Installing the TFT FL (Model 14.1 SHARP LQ141F1LH23)
To install the TFT FL (Model 14.1 SHARP LQ141F1LH23), follow the steps below and
refer to figures 4-85 to 4-89.
1. Install a new FL.
2. Seat the lamp cover on the LCD module aligning the holes on the lamp cover with
the pins on the LCD module. Let the P-chassis be outside by the outlet of the wire.
3. Fold the shield tape down.
4. Secure the lamp cover with two screws.
Screw
Lamp cover
Screw
Loosen the screws with 0.1176N⋅m (1.2kgf⋅cm) of torque.
Figure 4-85 Installing the lamp cover
To Next Page
Loading...
