2.4 System Board Troubleshooting 2 Troubleshooting Procedures
TECRA 9100 Maintenance Manual (960-347) 2-25
Table 2-3 Printer port LED boot mode status (6/6)
LED Status Test item Message
1Ch Setting up battery safe mode
Setting up date
Waiting for the end of AC-Link initialization
Waiting for the end of Bluetooth initialization
Updating DMI Wakeup factor and SM-BIOS structure table
Closing configuration space of PCI devices
Cache control
Updating parameter block A
Setting up the clock speed of the CPU to the appointed
value by the Setup
Waiting for the motor off of a disabled HDD
Concluding FDD information
Clearing power button status
Enabling the power button
FFh End
Check 1 If the following error codes are displayed, go to Procedure 5.
B0h, B1h, B2h, B3h, B4h, B5h, B6h, 00h, 01h, 02h, 03h, 04h, 05h, 06h, 07h,
08h, 09h, 0Ah, 0Bh, 0Ch, 0Dh, 0Eh, 0Fh, 10h, 11h, 12h, 13h, 14h, 15h, 16h,
17h, 18h, 19h, 1Bh, 1Ch, 1Dh, 1Eh
Check 2 If error code 81h or 82h is displayed, go to Section 2.5 FDD Troubleshooting and
Section 2.6 HDD Troubleshooting.
To Next Page
Loading...
