Toshiba Tecra M10 - Authentication of Fingerprint

2 Troubleshooting Procedures 2.18 Fingerprint sensor Troubleshooting
7. When the Store to Sensor screen is displayed, check Store fingerprint to Sensor. Click
Finish to complete fingerprint registration.
Procedure 3 Authentication of fingerprint
1. Turn on the computer to start up Windows.
2. In the Windows logon window, put lightly the first joint of your finger registered and slide
your finger sideways.
When authenticated, [Success] is displayed in the fingerprint authentication display.
When not authenticated well, warning message appears.
If you fail continually five times or more, you can not use the fingerprint authentication about
two minute.
When not authenticated, type the password to logon to Windows.
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 2-65