4.35 Fluorescent Lamp 4 Replacement Procedures
4. Separate the panel assembly and backlight unit.
CAUTION: Handle with care not to damage COF of S/D.
Panel assembly
Figure 4-79 Replacing 14.1-inch Samsung fluorescent lamp (WXGA) (4)
Installing the fluorescent lamp
The installing procedure of the 14.1-inch WXGA Samsung fluorescent lamp is the reverse of
the above disassembly procedure. Refer to figures 4-76 to 4-79.
1. Install the panel assembly on the backlight unit.
2. Install the top chassis on the molded frame.
3. Stick the yellow tapes, lamp-wire tape and bottom Al tape.
4. Stick the PCB cover.
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-121
To Next Page
Loading...
