4.35 Fluorescent Lamp 4 Replacement Procedures
Assembly of Source PCB
1. Assembly of Source PCB & Cover shield(S)1.
CAUTION: Pressure or stress should not be given on Source COF & Source PCB.
Usage of gloves with anti-electric discharge coating is recommended.
To eliminate possible damage on circuits occurred by ESC.
2. Assembly of Cover shield (G)2.
CAUTION: Pressure or stress should not be given on Gate COF.
3. Assembly of Tape Adhesive3 used for Top case fixing.
4. Assembly of Tape Adhesive4 used for B/L Wire fixing.
CAUTION: Pressure or stress should not be given on Top case during this process.
Figure 4-87 Replacing 14.1-inch LG fluorescent lamp (WXGA+) (8)
TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-129
To Next Page
Loading...
