4.6 Selectable bay module 4 Replacement Procedures
4.6 Selectable bay module
Removing the selectable bay module
The following describes the procedure for removing the selectable bay module. (See Figure
4-7 and 4-8.)
1. Turn the computer upside down.
2. Move the following screw (if the screw is secured in the lock screw hole) from lock
position to unlock position.
• M2.5x4.0B FLAT BIND screw x1
3. Pull out the selectable bay module from the selectable bay while sliding the lever.
M2.5x4.0B FLAT BIND
Selectable bay module
Lock position
Unlock position
Lever
Figure 4-7 Removing the selectable bay module
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-17
To Next Page
Loading...
