4.23 Microphone / Front panel 4 Replacement Procedures
4.23 Microphone / Front panel
4.23.1 Microphone
Removing the microphone
The following describes the procedure for removing the microphone. (See Figure 4-34.)
1. Remove the following screws securing the both right and left Mic holder.
• M2.5x4.0B FLAT BIND screw x2 (x1 for each side)
2. Pull up the Mic holder straight and remove the mic holder from the cover assembly.
3. Remove the microphone from the slot of cover assembly.
M2.5x4.0B FLAT BIND
Microphone
Mic holder (R)
Mic holder (L)
M2.5x4.0B FLAT BIND
Figure 4-34 Removing the microphone
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-55
To Next Page
Loading...
