4 Replacement Procedures 4.24 Lens holder
4.24 Lens holder
Removing the lens holder
The following describes the procedure for removing the lens holder. (See Figure 4-36.)
1. Remove the following screw securing the lens holder.
• M2.5x4.0B S-THIN FLAT BIND screw x1
2. Remove the lens holder from the cover assembly.
M2.5x4.0B S-THIN FLAT BIND
Lens holder
Figure 4-36 Removing the lens holder
Installing the lens holder
The following describes the procedure for installing the lens holder. (See Figure 4-36.)
1. Install the lens holder to the cover assembly.
2. Secure the lens holder with the following screw.
• M2.5x4.0B S-THIN FLAT BIND screw x1
4-58 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)
To Next Page
Loading...
