Toshiba Tecra M4 - Page 316

4.32 Fluorescent lamp 4 Replacement Procedure
Folding the FPC/PCB
1. Fold down the FPC (PCB) toward the reverse side of the backlight unit.
CAUTION: 1. Be careful not to damage the FPC.
2. The screw hole shall be seen.
The screw hole of plastic
frame shall be seen
through the hole of GND-
CU.
The screw hole of plastic
frame shall be seen
through the hole of GND-
CU.
Figure 4-56 Replacing 14.1 Inch TMD fluorescent lamp (8)
TECRA M4 Maintenance Manual (960-521) [CONFIDENTIAL] 4-85