Toshiba Tecra M4 - Page 317

4 Replacement Procedure 4.32 Fluorescent lamp
Setting the bezel
1. Fit the bezel into the frame from the lamp side. ((1) in the bellow figure)
2. Hook the four (two positions on each side) latches on the side. ((2) in the bellow
figure)
3. Fit the bezel hooking the three latches on the upper side (FPC side). ((3) in the bellow
figure)
CAUTION: Be careful not to damage the cell, FPC and B/L.
(
3
)
Hook the latch on the u
pp
er side and fit the bezel.
(2) Hook
latches on the
side.
(2) Hook
latches on the
side.
(1) Fit
the bezel
from the
lamp
side.
Figure 4-57 Replacing 14.1 Inch TMD fluorescent lamp (9)
4-86 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)