Toshiba Tecra M9 - Removing the Cover Assembly and Base Assembly

4.14 Cover assembly and Base assembly 4 Replacement Procedures
4.14.2 Removing the cover assembly and base assembly (Smart card Model
only)
The following describes the procedure for removing the cover assembly and base assembly.
(See Figure 4-24 and 4-SC4.)
7. Close the display and turn over the computer.
8. Remove the following screws.
• M2.5×8B FLAT HEAD screw ×3 (“8” in the figure below)
• M2.5×16B FLAT HEAD screw ×6 (“16” in the figure below)
8
8
8
16
16
16
16
16
16
Figure 4-24 Removing the cover assembly and base assembly (1)
TECRA M9 Maintenance Manual (960-631) [CONFIDENTIAL] 4-47