4.36 Fluorescent Lamp 4 Replacement Procedures
Disassembly of Board Ass’y, Tape Adhesive, Sheets, Light guide, Cover Ass’y Bottom
1. Disassembly of Top Case1.
2. Disassembly of Board Ass’y2.
CAUTION: This process should be made in Clean room with no scratch nor particle on
Polarizer and B/L Ass’y.
3. Disassembly of Tape Adhesive3 used for Sheets fixing (4Points).
4. Disassembly of Sheets and Light guide4.
CAUTION: No penetration of foreign body is indispensable with no scratch on the
surface of each Sheet.
5. Disassembly of Screw (2Points) and Cover Ass’y5.
CAUTION: Maximum value of torque with Screw should be below 2.5kgf.
Figure 4-72 Replacing 15.4-inch LG fluorescent lamp (WXGA) (4)
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-115
To Next Page
Loading...
