User’s Manual 4-11
Operating Basics
Loading discs
To load CD/DVDs, follow the steps below.
1. When the computer’s power is on, press the eject button to open
the disc tray slightly.
2. Grasp the disc tray gently and pull until it is fully opened.
Figure 4-4 Pressing the eject button and pulling the disc tray open
3. Lay the CD/DVD, label side up, in the disc tray.
Figure 4-5 Inserting a CD/DVD
Disc tray
Laser lens
When the disc tray is fully opened, the edge of the computer will extend
slightly over the CD/DVD tray. Therefore, you will need to turn the CD/DVD
at an angle when you place it in the disc tray. After seating the CD/DVD,
however, make sure it lies flat.
Downloaded from LpManual.com Manuals
To Next Page
Loading...
