Toshiba TH650A-IP - How to Connect Connectors

STE 80747
– 27 –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
JOEP
JOFP
JOES
JOFS
JOES
JOFS
Disconnect
connector (on CN4
side)
Cable lead-in port
Cable clamp 12-mm ID (1 place)
From PLC, etc.
Motor cover
Type of contact: BHF–001T–0.8SS (Maker: J.S.T. Mfg.)
Adaptive cable: Conductive cross section area 0.2 mm
2
~ 0.3 mm
2
Opposite connector type
Type of connector: JOEP SMR–07V–B (Maker: J.S.T. Mfg.)
JOFP SMR–06V–B (Maker: J.S.T. Mfg.)
Type of contact: BYM–001T–0.6 (Maker: J.S.T. Mfg.)
Fig. 4.1 Wiring to PLC, etc.
4.1.1 How to Connect Connectors
The motor cover of the dust-proof and drip-proof type robot is equipped with a cable
clamp (dust-proof and drip-proof construction). To connect the cables from the
separate PLC, etc., use this cable clamp to connect them with the connectors in the
robot.
When routing the connection cable through a cable clamp, use a shielded cable clamp
of 6.0~12.0-mm OD.
Fig. 4.2 How to connect cable to connector
Cable clamp
Cap
Filler
(rubber)
Rubber
bushing
Connectors
(JOFS, JOES)
User cable
From PLC, etc.
Rubber bushing
To be soldered.
Cover