STE 80747
– 44 –
DUST-PROOF & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
6. Cleaning Robot Body
To clean and wash the robot body, be sure to use a neutral detergent. Use a soft
sponge and waste cloth, and take careful precautions not to cut or scratch the robot
body.
Rinse the robot body in compliance with the specified values corresponding to the
ingress protection class to protect the robot against water. Be sure to rinse the robot
while purging air.
!
DANGER
• Be sure to turn off the controller power supply and to pull out the power plug
before cleaning work. If you do not follow the instruction, this will cause an
electric shock or fault, which can be dangerous.
• After cleaning, completely wipe out the water.
!
CAUTION
• Be sure to use a neutral detergent to clean and wash the robot body. If a
detergent (such as chlorine detergent and acid detergent) other than the
neutral detergent is used, the paint may deteriorate, or the cover or bellows
may be damaged.
• Be sure to rinse the robot body while purging air. It is not be done completely,
the dust-proof and drip-proof performance will be impaired resulting in ingress
of water.
To Next Page
Loading...
