Toshiba THP700-IP - How to Connect Connectors

DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
STE85336
– 21 –
Type of connector: JOES SMP–11V–BC (Maker: J.S.T. Mfg.)
JOFS SMP–10V–BC (Maker: J.S.T. Mfg.)
Type of contact: BHF–001T–0.8SS (Maker: J.S.T. Mfg.)
Adaptive cable: Conductive cross section area: 0.2 mm
2
~ 0.3 mm
2
Opposite connector type
Type of connector: JOEP SMR–11V–B (Maker: J.S.T. Mfg.)
JOFP SMR–10V–B (Maker: J.S.T. Mfg.)
Type of contact: BYM–001T–0.6 (Maker: J.S.T. Mfg.)
Adaptive cable: Conductive cross section area: 0.2 mm
2
~ 0.3 mm
2
Fig. 4.1 Wiring to PLC, etc.
4.1.1 How to Connect Connectors
The motor cover of the dust- and drip-proof type robot is equipped with a cable clamp
(dust- and drip-proof construction). To connect the cables from the separate PLC, etc.,
use this cable clamp to connect them with the connectors in the robot.
For the cable clamp, use a cable with shield, whose outer diameter is 7.0 to 13.0 mm.
Disconnect.
(HAND side)
JOES
JOFS
From PLC,
etc.
Cable inlet, 1 place
JOES
JOEP
JOFS
JOFP
Cable clamp
Cable diameter
range: φ9 to φ14