Toshiba THP700-IP - Page 24

DUST- & DRIP-PROOF TYPE SPECIFICATIONS MANUAL
Input/output signal connector CN0 (Type-N)
Pin
(Cannon)
Signal name
Signal
No.
Input/output circuit
and example of connections
A D-IN0 Input signal 0 201
B D-IN1 Input signal 1 202
C D-IN2 Input signal 2 203
D D-IN3 Input signal 3 204
E D-IN4 Input signal 4 205
F D-IN5 Input signal 5 206
G D-IN6 Input signal 6 207
H
D-IN7 Input signal 7 208
J P24G (P24V) 0V (24V)
K P24G (P24V) 0V (24V)
L FG
N Not used
M Not used
P Not used
Q D-OUT0 Output signal 0 201
R D-OUT1 Output signal 1 202
S D-OUT2 Output signal 2 203
T D-OUT3 Output signal 3 204
U D-OUT4 Output signal 4 205
V D-OUT5 Output signal 5 206
W D-OUT6 Output signal 6 207
X D-OUT7 Output signal 7 208
Y P24G (P24V) 24V (24V)
Z P24G (P24V) 24V (24V)
P24V
Customer’s side
Minus common (X8GN)
Customer’s side
Diode for
preventing counter
electromotive
voltage
Plus common (X8GI)
Customer’s side DC relay drive
DC relay
Diode for preventing
counter electromotive
voltage
* For Type-P, the signal names of pin numbers 9, 10, 22, and 23 are in parentheses ( ).
As input signals, no-voltage contacts or transistor open collector inputs are used.
No-voltage contact specification:
Contact rating: DC24 V, 10 mA or over (circuit current: approx. 7 mA)
Minimum contact current: DC24 V, 1 mA
Contact impedance: 100
Ω or less
Transistor specification:
Withhold voltage between collector and emitter: 30 V or over
Current between collector and emitter: 10 mA or over (circuit current: approx. 7 mA)
Leak current between collector and emitter: 100 µA or less
STE85336
– 23 –