Toshiba TLP-SX3500 - PICTURE-2 Menu

34
Multifunctional Settings (continued)
Multifunctional Settings (continued)
PICTURE-2 Menu
With the PICTURE-2 menu, the items shown in the table below can
be performed. Perform each operation in accordance with the
instructions in the table below.
memo This menu cannot be selected at a M1-D signal.
: SELECT
MENU
MAIN
PICTURE-1
PICTURE-2
INPUT
AUTO
SCREEN
OPTION
NETWORK
V POSITION
H POSITION
H PHASE
H SIZE
OVER SCAN
RESET
20
142
31
1344
5
Item Description
V POSITION
Adjust the vertical position using the / buttons. :
Up  Down
memo This item cannot be selected for a M1-D signal.
H POSITION
Adjust the horizontal position using the / buttons. :
Left  Right
memo This item cannot be selected for a M1-D signal.
H PHASE
Adjust the horizontal phase to eliminate flicker using the / buttons. :
Right  Left
memo This item can be selected only at a RGB signal or a component video
signal other than a COMPONENT port input of 525i(480i)/625i(576i)/SCART
RGB.
H SIZE
Adjust the horizontal size using the / buttons. :
Large  Small
memo This item can be selected only at a RGB signal.
memo When this adjustment is excessive, the picture may not be displayed
correctly. In such a case, please reset the adjustment pressing the RESET
button during this operation.
OVER SCAN
Adjust the over-scan ratio using the / buttons. :
Small  Large
memo This item can be selected only at a video signal.
memo When this adjustment is too large, certain degradation may appear at
the frame area of the picture. In such a case, please adjust small.
RESET
Select the EXECUTE using the button to reset the PICTURE-2 menu items. :
EXECUTE  CANCEL
The items of the PICTURE-2 menu are collectively returned to the initial setting.
Note that the item “H PHASE” is not reset.