• Be sure to use the designated wire. Failure to do so could lead to fires or
faults.
• When connecting the connector and wires, make sure not to mistake the
terminal arrangement.
• After making the connection, use a tester, etc., to confirm the connection.
• Unless the main power is normally supplied to the controller due to phase
defect or voltage drop, an error of “8–027 Slow Charge error” occurs. When
this happens, make sure that the maser power voltage at the controller
power connector satisfies the specified input power of the controller, and that
the same voltage is stabilized.
• For details on "8-027 Slow Charge error," see the "Instruction Manual:
Alarms" provided as a separate volume.
To Next Page
Loading...
