Disassembly and Reassembly
Toshiba
4-13
1-2-16 Holder Clutch Ass
’
y Removal
1) Remove the Washer Slit Œ.
2) Lift the Holder Clutch Ass’y ´.
Note
: When you reinstall Holder Clutch Ass'y
1) Check the condition of spring as shown in detail A.
2) Don't push Holder Clutch Ass'y down with exces-
sive force Just insert Holder Clutch Ass'y into post
center with dead force and Rotate it smoothly.
Be sure to confirm that spring is in the slit of Gear
Center Ass'y as shown in detail B.
Œ
DISK S REEL
´
DISK T REEL
Œ
WASHER SLIT
´
HOLDER CLUTCH ASS`Y
DETAIL A
<BAD> SPRING <GOOD>
<BAD>
SPRING
<GOOD>
DETAIL B
Fig. 4-24 Disk S, T Reel Removal
Fig. 4-25 Holder Clutch Ass
’
y Removal
1-2-15 Disk S, T Reel Removal
1) Lift the Disk S, T Reel Œ, ´.
To Next Page
Loading...
